10-21-2010, 07:48 PM
Join Date: Nov 2008
Location: Satellite Beach, FL
| | 10nd guys, question for you about pinion angle????
I'm getting 1.66 60ft's but I know I could do a little better. My whole rear is supported by BMR and it's all adjutable. I've found the sweet spot running 15 psi in my mickey thompson's. I'm wondering where I could adjust to get it to hook a little better. I'm set pretty much at stock settings with the panhard, control arms and -2 degree's on the Tq arm. I was wondering if I should adjust the torque arm but really dont know which way to go. Any advice on where i should set it. Thanks for the advice.
I would rather push a chevy then drive a ford!
Forged 355 LT1 equiped with AI H/C/I, ARP everything, Hooker super comp LT's through magnaflow x-pipe to dynomax bullets dumped, 58mm BBK TB, EWP, LS1 lid conversion, 3600 vig stall with FLT level 4 trans, 3:73 gears, Full blown suspension ranging from BMR, STRANGE and MWC fab9, plans of a 150 shot in the future, Nothing stock but the block