10 Second Club Now you are haulin! 10s are sweet

what does it take to hit 10s in a fbody?

Thread Tools
 
Search this Thread
 
Old 02-19-2011, 06:11 PM
  #21  
8 Second Club
iTrader: (31)
 
ls1curt's Avatar
 
Join Date: Jun 2009
Location: CT
Posts: 1,206
Likes: 0
Received 3 Likes on 3 Posts

Default

i bet you would be high 10's right now depending on your 60 ft. i was an 11.3@125 with a 383 and prc 5.3 heads/ms4/fast 90 and a slipping clutch. 00back SS- just send your 243's to a.i. and you should be easy 10's
Old 02-19-2011, 08:39 PM
  #22  
10 Second Club
iTrader: (1)
 
odarabla's Avatar
 
Join Date: Sep 2007
Location: In Uranus!
Posts: 1,500
Likes: 0
Received 0 Likes on 0 Posts
Default

With a little spray you can reach your goals.
Old 02-21-2011, 09:52 AM
  #23  
TECH Enthusiast
Thread Starter
iTrader: (9)
 
00 black ss's Avatar
 
Join Date: Sep 2008
Location: Long Island, NY
Posts: 609
Likes: 0
Received 1 Like on 1 Post
Default

Originally Posted by SSHAWK
Have you taken the car to the track ?? Would be nice to have some numbers to go off of. So we can tell you how close the mods you listed will get you to your goal.

Suspension sponsor will say Lca will get you a .1 tenth
92/92 with lid 1 to 2 tenths
Drag bar will drastically improve 60-foot times as well as consistency.

So total
lca...... .1 tenth
92/92 and lid ..... .2 tenth
drag bar....... .1 tenth

4 tenths of a second.


If you run low 11's right now you might get there but would be nice to see what your times were before.

Again this is just my .02

You could have a lot better 60ft and get it even better I just don't know.
havent ran the car since i swaped motors. my old setup was just a ms3 bolt on ls1 with 4.10s and **** 10 bolt and i ran a 12.0 now everything is upgraded from that setup.
Old 02-24-2011, 11:20 AM
  #24  
10 Second Club
iTrader: (14)
 
SSHAWK's Avatar
 
Join Date: Jan 2010
Location: Forney, Tx
Posts: 468
Likes: 0
Received 1 Like on 1 Post

Default

Originally Posted by 00 black ss
havent ran the car since i swaped motors. my old setup was just a ms3 bolt on ls1 with 4.10s and **** 10 bolt and i ran a 12.0 now everything is upgraded from that setup.
Yeah when you change everything its kind of hard to give you some numbers but..... with what you have if everything goes right you should be close.

Good Luck let us know how it goes.



Quick Reply: what does it take to hit 10s in a fbody?



All times are GMT -5. The time now is 03:32 PM.