Best head Gasket out there for spray?????
Thread Starter
9 Second Club
iTrader: (34)
Joined: Mar 2005
Posts: 2,248
Likes: 0
From: SPRINGFIELD MISSOURI
Best head Gasket out there for spray????? Just wanted some opinions on what is the best head gasket for nitrous. I have heard ls9 gaskets or MLS.
This is for a 300 shot of spray on a Iron block.
This is for a 300 shot of spray on a Iron block.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
I used the stock GM 5.7L MLS gasket on my old 346. I hit it with a 300 shot right out of the gate with no issues except a broken 12 bolt and tranny. I use the stock 6.2L MLS gasket now but I haven't been able to spray it yet.
I run the ls9 gaskets on my ls2 but it just went together. The copper spray you just hang the gasket spray both sides let it get tacky then through it on. My tuner runs the ls9's with copper spray on plenty of cars he built ranging from my car 420's-1100whp cars. I only spray 100 but will most likely work up to a 150 shot Friday at the rental.
The copper spray helps coat and keep the gasket sealed to the deck.
It is a good trick. Some grudge racers I know also swear by using that block seal **** with copper in it for their radiator and cooling system.
I think it's mainly the copper that helps seal than the rest of that **** in block seal.
Copper head gaskets are what some heads up racers under big boost or nitrous.
It is a good trick. Some grudge racers I know also swear by using that block seal **** with copper in it for their radiator and cooling system.
I think it's mainly the copper that helps seal than the rest of that **** in block seal.
Copper head gaskets are what some heads up racers under big boost or nitrous.
I hit a pretty healthy shot with the good old 5.7L GM MLS, installed dry. This was a fairly simple build though. Wasn't really concerned about quench, or anything. For the price and availability, they were a great gasket.
