BashamWS6

iTrader: (8)

Alright ive loked everywhere and cant find a straight answer.

I have 99 ws6 with bolt ons. soon to be d1sc with 411s thru a s60

what tire should i put on my weld 15x10s?

MM98

iTrader: (13)

Definitely go with a 28".

BashamWS6

iTrader: (8)

will that fit under my fenders? and would i need adjustable lcas? and what if im lowered?

MM98

iTrader: (13)

I'm running 275/60's & have BMR 1" springs.. I just had to roll the fenders.. I'm using Spohn non-adjustable lca's & the tires are pretty centered with no clearance problems. But I'm also on a 9" Convo pro rim w/ 6.5 bs. The 10" rim w/ a 7.5 bs might need the bump stops trimmed & inner fenders hammered if you're lowered.

BashamWS6

iTrader: (8)

would i need tubes for that? and i know i will need spacers for the fronts.

BOBS99SS

iTrader: (2)

28s for sure, i run a 275/60/15 if your lowered pending on how much you will at least need to roll fenders/maybe a lil bh etc nothing to crazy,

blackls1ta00

iTrader: (27)

ta's have alittle more room in the wheelwell,275/60/15 should fit without any problems,if anything just alittle of a bfh

SF 1HOTLS1

iTrader: (24)

if your a 6spd car or an auto with a t brake then a 28. if your an auto with no trans brake, then a 26. i have an auto with no t brake and a 28 just lowered my 60ft times. if you dont have the force of dumping the clutch then a 28 will slow u down imo. its just to tall of a tire and needs that force from a 6spd or t brake to get it going.

edwardzracing

iTrader: (59)

I disagree that 26" would be the way to go with his car. A supercharged car with 4.11's is not going to have any problem getting out of it's own way. My recommendation would be a 28" tire for sure. Otherwise you're sure to run out of gear at the top end.

blown97ss

iTrader: (8)

i agree with a 28 i personally have a 26 in my car with 373s if i spin off the line in i red line the car at the end. if it dead hooks i finish the pass at the very top of my 3rd gear. you will be out of gear in a a4 car with a 26 and 411 gears.

flintwrench69

iTrader: (11)

I was told dont use tubes unless you use screws in the rim to prevent the tire from spinning or you could rip the valve stem of the tube & there goes all your air pressure. Tubes also add more weight.