Electronic spark failure?
08-23-2008, 01:38 PM
#1
Teching In
Thread Starter
Join Date: Mar 2008
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Electronic spark failure? I just scanned my car and 43 electronic spark control failure came up. Im not to sure where to go from here any suggestions would be great, Thanks
08-24-2008, 12:19 AM
#3
TECH Fanatic
iTrader: (5)
Join Date: Mar 2004
Location: Melrose, MA
Posts: 1,196
Likes: 0
Received 0 Likes
on
0 Posts
If your going to have to replace a knock sensor, I would be using AC delco (factory) parts if possible. Especially for anything electronic.
The knock sensor is an easy install, pull the PCM out and its right in the backside.
The knock sensor is an easy install, pull the PCM out and its right in the backside.
08-24-2008, 08:45 AM
#4
Teching In
iTrader: (2)
Join Date: Jan 2005
Location: Gladewater, TX
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Uh, not quite. That's the code for the knock sensor in the block, not the knock module, that is located in the PCM.
I have a good bit of experience in popping knock sensors.
I have a good bit of experience in popping knock sensors.
08-24-2008, 09:55 AM
#5
TECH Fanatic
iTrader: (5)
Join Date: Mar 2004
Location: Melrose, MA
Posts: 1,196
Likes: 0
Received 0 Likes
on
0 Posts
Ahhhh, knock sensor.....knock module..... same thing
Your right, brain fart in the early A.M.
But yeah leadfart is of course right, its the sensor in the side of the block and NOT THE MODULE IN THE PCM!!! FIXXER99TA IS A MORON!
Your right, brain fart in the early A.M.
But yeah leadfart is of course right, its the sensor in the side of the block and NOT THE MODULE IN THE PCM!!! FIXXER99TA IS A MORON!
