Engine Bay clean out ?s
#1
On The Tree
Thread Starter
Join Date: Nov 2009
Location: Canby, Oregon
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
Engine Bay clean out ?s
I want to clean out my engine bay. But i have noticed that its discolored and different mystic teal green blotches everywhere. I am planning on a nice wash with water, soap, and scrubber with degreaser.
Im not looking for a show car finish but i want it where it looks nice and not "hey, i dont care about my car" look (lol). Any tips on that?
Also, another question i have is when repainting the engine bay, what did you guys do with the front wiring?? Just put it off to the side and paint around it?
Thanks
Karl
Im not looking for a show car finish but i want it where it looks nice and not "hey, i dont care about my car" look (lol). Any tips on that?
Also, another question i have is when repainting the engine bay, what did you guys do with the front wiring?? Just put it off to the side and paint around it?
Thanks
Karl
#4
Launching!
Join Date: Sep 2004
Location: Orange County
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
There was a write up awhile back..guys were saying sg was not good for the alum....I jus use soap and water...and alot of scrubbing...when I get done I spray it down w wd40 for tht gloss look...wrks for me
#6
10 Second Club
iTrader: (30)
Like I said simple green works awesome and quickly for anything.. just make sure you wash it off really well.. that applies to aluminum parts as well.. if you wash it off it will not have a chance to be corrosive.. too many damn scaredy cat people on this board lol.. its just water! Rinse good!
#7
12 Second Club
iTrader: (5)
Join Date: May 2009
Location: pooler, ga
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
i would listen to djfury iv seen his engine bay in person an its prolly one of the cleanest iv ever seen. i sprayed my engine bay down with water, soaked it in simple green and let it set for about 10 min, rinsed the crap out of it and then took a leaf blower to get it out of all the small cracks. if you want to take it even farther you can get some mothers billet polish and go to work on your abs block, ac condenser and any other aluminum things you can find and it will really sine.