GMC5.3

iTrader: (2)

Looking for any guidance what so ever, got some dual halos for Christmas and having no clue how to install. Between the hid kit and the headlight itself I'm totally lost, didn't find any write ups witch doesn't make me feel any smarter about not being able to do this. Any write-ups or can anyone please help out


The sonar halo headlight


HID bulb installed, now where do positive and negative cables go?



HID ballast connected but not sure where the positive and negative wires for the halos connect to?


Thanks for any help

Z28Dave

iTrader: (10)

Where do those 2 wires come from? are they from the halo rings? when i had my sonars they were pretty much plug and play i dont recall any wires without clips. cant hurt to clip them into a power and a ground. i clipped mine into the foglights

GMC5.3

iTrader: (2)

The red and black wires came from the hid bulb which I installed into the headlight, what I don't understand is how does the female connector from the car come into play here?
Pic of the hid ballast and bulb connected and put into light.


Here is the previous bulb setup which would of been plug and play

GMC5.3

iTrader: (2)

Here's the HID diagram, I would like the hi/low in figure two

GMC5.3

iTrader: (2)

Haha maybe I got it, so those red and blacks just connect straight into the female connector from the car like below, then I believe I'm set right? Anyone confirm

SomDay

Please post some pictures of the low beams when you get them installed and aimed. I have these on my car but, the low beams are horrible.

VIP1

This thread is from over 4yrs ago.