All emblems replaced - Black Onyx Stainless EmblemPros with black inserts
Trending Topics
#8
TECH Veteran
iTrader: (7)
Join Date: Jun 2006
Location: Bay Area California
Posts: 4,409
Likes: 0
Received 0 Likes
on
0 Posts
Agreed. Now there is too much going on and the emblems do look out of place IMO. THe inserts look great and if you must keep the WS6 ones, I would only keep the rear one and remove the ones on the front fenders.
#12
TECH Regular
Thread Starter
iTrader: (14)
Join Date: Apr 2005
Location: Tampa, FL
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
Well I like them, that's all that matters. Everyone's entitled to their opinion though.
It might help a little if I explained my future plans of Weld RTS wheels, in the black finish. I think they will go VERY well with the onyx.
It might help a little if I explained my future plans of Weld RTS wheels, in the black finish. I think they will go VERY well with the onyx.
Last edited by contraststriker; 04-26-2014 at 06:01 AM.
#13
11 Second Club
iTrader: (127)
Join Date: Jun 2002
Location: MS
Posts: 984
Likes: 0
Received 0 Likes
on
0 Posts
I like em man! Looks good to me and never been a big fan of the Z06 style badges, but they look sinister in onyx. Emblems placement is limited on these cars given the vents on fenders. Doors look better clean, imo. Good job.
#16
sorry man.....Roger does great work, but even those wheels wont save your choice on emblems. And unless you plan a 3" offset out back you might pull it off...otherwise......
#17
11 Second Club
iTrader: (127)
Join Date: Jun 2002
Location: MS
Posts: 984
Likes: 0
Received 0 Likes
on
0 Posts
Good grief guys. Based on some of your comments, you would think this was a thread about the OP running over your dogs. At least he can't say y'all sugar coated your opinions. LOL. Brutally Honest.