shippershack

I just installed the FRC's on my HAwk, and a true Pita indeed to get that driver side to fit. On my searches for install tips I noticed that some sites recommended applying heat shield tape to the underside to protect them. Anybody NOT do this, and still seem no damage....am I safe not doing it?

XtinctHawk02

I didn't do it. But I have real carbon fiber cover's. I did re-tape my fuel lines though.

ddelallata

iTrader: (2)

I didn't use any and have had no problems. I am using LT headers too.

dfarmercse

I didn't tape mine and drove to Fl and back. 500 miles each way and haven't had any problems

parbreak

iTrader: (17)

From someone who's made over 250 sets of these, I say it's cheap insurance just in case. It's $15.00 for a roll from Eastwood. That beats the hell out of ruining a $250-300 set of FRCs if the motor overheats. Granted I have Jet Hot Longtubes and have run my FRCs without the tape, but it's not a daily driver sitting in traffic and I pull them when I go to the track.

Bryan
parbreak