BlkBrdWS6

iTrader: (1)

Hey guys! I was really thinking about removing the side molding on my silver WS6 because I really like the clean looks it gives. But I like the Trans Am badge on the door and just put overlays on them. Would it look tacky if I removed the side molding, but left the Trans Am badge on there? Any pics of this? What do you guys think, give your honest opinions, thanks!

ritz

iTrader: (1)

IMO it would. I removed my moldings took a look to see how the TA badges looked and needless to say they were removed ASAP.

waterbug1999

iTrader: (3)

These are some that I have. To me, either or.

2K2WS6TA

iTrader: (2)

I left mine on, it doesn't look tacky to me

Sgt. Spuds

iTrader: (1)

mine are off.

_JB_

iTrader: (33)

Removed molding and I left mine on with SS overlays, love it.

peterlawl84

iTrader: (12)

i removed the molding and left the trans am on the doors, i dont think it looks tacky either. but i left mine nmb so it blends in also.

nhra-trans-am

iTrader: (103)

with

without

skatinjay27

ls1 cars look good with out, lt1 cars look way too plain with out

nostyta

iTrader: (6)

Removed the side molding and left the Trans Am badges on mine, I like it.

RollTideTA

I dont think the lettering looks right without the molding and thats why my car still has the molding, it sort of frames my emblems and just didn't look right in photoshops I did of my car with out it.

You could take some vinyl or stainless steel overlays and put them in the place of the Trans Am raised lettering. They would be more flat and wouldn't stick out like the stock emblems. That would look better, but I think I'm just sticking with leaving my molding on this car unless I go without anything down there.

ritz

iTrader: (1)

Well since everyone else is posting theirs I'll post mine. This is my old car. I prefer the "clean" look.

Before


After

Ling_650vette

iTrader: (1)

I like it both ways, but if I had a TA I'd rather have the lettering along the side with !moldings.