nightshade FTL
#1
TECH Fanatic
Thread Starter
iTrader: (6)
Join Date: May 2004
Posts: 1,893
Likes: 0
Received 0 Likes
on
0 Posts
nightshade FTL
man i dont know how you guys sprayed this stuff without it running like crazy, i had to redo one of my tailights 2 times and i still got runs in it, the other one isnt too bad but my side markers also came out like ***, i have to call summit racing cuz one of the cans had the tip broken off and was only like 1/2 full, so maybe ill remove them with paint thinner and try it again, anyone have any suggestions on how to not get runs? i read the sticky but still had runs.
#6
TECH Fanatic
iTrader: (3)
Join Date: Jun 2004
Location: Sacramento CA
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by keliente
If you're getting runs you are spraying waaaaaaaaay too much. Spray just a little bit on there at a time, let it dry ~10 minutes in between.
#7
TECH Enthusiast
iTrader: (7)
Join Date: Sep 2005
Location: Dallas, TX
Posts: 527
Likes: 0
Received 0 Likes
on
0 Posts
I did the sidemarkers and CHMSL on my T/A and now the taillights on my GTP with two cans from AfterThoughts. I didn't sand anything. I just cleaned them up, dried with a microfiber towel and sprayed away. No runs.