mikes98z

iTrader: (9)

Guys,

Have any of you powdercoated the maf itself (not the ends)? I have a small p/c shop and I am in the process of coating brackets and a lot of little odds and ends to dress up my T/A during its restomod. I was wondering if the small sensor/wire in the middle would get hosed during the curing process because it is so thin. I do not want to destroy my maf on a trial by error basis.

Thanks!
Mike

Havok2

iTrader: (118)

i wouldnt, cus if you mess with those reisitors, off you go to get a new maf.