manual valve body plese help!!
11-14-2008, 04:09 PM
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: Aug 2006
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
manual valve body plese help!! so ive had nothing but problems with my transmission and now to add another one. i had the trans rebuilt with a manaul valve body and now it wont move. i installed everything as i normally do and ran the vacuum line to the break booster. i started the car today and now it wont move!!! what could cause this?? also the trans is a built 4l60e with a yank 4000 stall.. it goes into reverse but u have to give it alot of gas for it to move. it goes into first but you have to be at wot to move the car an inch. could it be the vacuum line? any ideas please!!!!
11-14-2008, 04:28 PM
#2
Unhook a trans line and start car if fluid does not spray you have broken the pump during install.
I have also seen where the PR valve in pump snap ring was not fully seated and the PR valve popped out if so it will be laying in the pan
I have also seen where the PR valve in pump snap ring was not fully seated and the PR valve popped out if so it will be laying in the pan
__________________
