th350 convertor ?
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Nov 2008
Location: Keezletown, Va
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
th350 convertor ?
Im putting a th350 into an 98 ls1 camaro. I bought the Hughes crank sleeve to fit the th350 convertor to the ls1 flexplate. I have no play in the convertor. It will turn put in wont move foward or back. I have heard you need an 1/8th of play in the convertor. Is this true? If so what do I need to do to get it to work?
Thanks,
Ricky
Thanks,
Ricky
#5
TECH Regular
iTrader: (10)
Join Date: Nov 2001
Location: Florida
Posts: 487
Likes: 0
Received 0 Likes
on
0 Posts
The hughes adapter may not be fully seated in the rear of the crank. I had to use a rubber mallet to fully bottom it out. The adapter is a loose fit on the convertor but a tight fit in the crank.
If your adpater is fully seated, then your converter is not all thw way, OR you have convertor that was built for a TH350/400 to LS1 already and do not need the adapter.
Hope this helps,
Rick
If your adpater is fully seated, then your converter is not all thw way, OR you have convertor that was built for a TH350/400 to LS1 already and do not need the adapter.
Hope this helps,
Rick