OD and drive doesnt pull
04-16-2011, 11:54 AM
#1
TECH Enthusiast
Thread Starter
iTrader: (11)
Join Date: Oct 2006
Location: Greenville,NC
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
OD and drive doesnt pull Ok just did my 12 bolt swap. And went to drive car, it doesn't pull in OD or D. I can pull it down into 2 or 1 and I feel it grab. As i drive it I can manually shift it and all the gears are there including lockup. But when I stop I feel the tranny neutral out again. Any tips or did i accidentally unhook something while under there?
04-16-2011, 12:26 PM
#3
TECH Enthusiast
Thread Starter
iTrader: (11)
Join Date: Oct 2006
Location: Greenville,NC
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
Sounds about right! I busted my 10 bolt at track reason for the rearend swap. Just what I need after dropping 3800 for new rearend and suspension!!
04-16-2011, 01:18 PM
#5
Moderator
iTrader: (1)
Join Date: Sep 2005
Location: Bloomingdale Illinois
Posts: 8,633
Likes: 0
Received 0 Likes
on
0 Posts
The input sprag failure is pretty common when breaking a rear end. I have also seen where the low roller takes a whack as well. Make sure to address these when you have it apart. Vince