Jpack

iTrader: (12)

I got this driveshaft when I purchased my Rossler th350. I was wondering if anyone might know who makes it. It is 3.5", all aluminum. Center to center on the u joints is 41" It appears to be 1350 ujoint in the yoke, but the rear is smaller. I am going to have it shortened to work with the new dana s60 and swap the *** end to 1350. There are no markings on the shaft itself. Yoke says MDI MTS. I'm just trying to find out who makes it. Previous owner couldn't recall. Held up fine on his old set up behind the trans brake though.