Big bird55

iTrader: (1)

I bought the b and m lock up kit for my 700r4 and when I went to remove the spring in the vavle body like the instructions said to I found I didn't have the spring the instruction says to remove. I circled in red what I pulled out of the vavle body and now I do not know if I am missing parts or not. What is circled was the only thing that came out. If it is all ok what do I do instead since I do not have the spring? do i just go out about wiring it up like the instructions says. Never messed with a 700r4 so this is confusing the hell out of me

zgp

your good, it is not needed.

Big bird55

iTrader: (1)

ok thanks but am i missing parts? Or are they just showing 2 different setups

pricesgarage

1982-86 uses that spring 87 up uses the top sleeve

pricesgarage

is that the 4th gear switch kit or the hyd lock up were it doesnt require any ecm ?

Big bird55

iTrader: (1)

the kit i bought is just a b and m kit that use vehicle speed of the speedo cable to tell the converter to lock up. can swap the parts to an 82-86 and it work or will it work like it is now?

pricesgarage

yes because the lock up is controlled by voltage the speedo switch just completes the circuit you should not have to do any vb mods