You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join LS1Tech.com today!
Being Adamant that I was Not goin to pay $150 for a slip yoke, my searches finally paid off. My apologies to the sponsors that sell said yokes. Thought i would share my findings with other members you are not in the "Fortunate Sons" Social class. I found my slip yoke through a nonsponsor, so if you are interested, then pm me and I will send you info. The slip yoke is made by Neapco, product number N3-3-2431X (1350 yoke). The yoke is 31/32 spline, measuring 5.5 inches in length (from center ujoint to tip of yoke), with .5 inch counter-bore. Measurments match that of the bolted yoke that the 4l80e uses. Pics Below. Price was $89.75 Shipped to me!!!!!
A lot better than $150. This Yoke is comparable to Spicer brand yokes.
I Didn't Come Here to Impress You. That's a Bonus! You're Welcome.
I can confirm that this yoke works and looks to be great quality. When i was searching for it i found several on ebay and other sites that had a similar number with the same dimensions but the notes did not specify if it was counterbored. These others were cheaper and possibly lower quality without the counterbore. Thanks for posting this up it was a great help to me. Im using it on my 2004 single cab Silverado with stock 1 piece driveshaft works perfectly. This is where I purchased mine for anyone else looking: http://www.northerndrivetrain.com/pr...3-3-2431X.html
__________________ 04 SCSB, Juan trannys 4l80e ran off 4l60e tune
Slp 224 228 113, Cold air, 1 7/8 TSP long tubes
dual 3" into 4" magnaflow exhaust.
I got mine from Denny's for $75. It's a TH400 long yoke so the barrel is 6", but the last 2" are counterbored. It will likely need to be shortened slightly, but it will maximize the amount of spline engagement.