turyg ls1

iTrader: (2)

When shifting to reverse its ok but when i shift to neutral it stays in between neutral & D & then it just stays in between the rest of 3-2. Am i the only one with this issues?

Burken01

iTrader: (88)

The linkage plate that attaches to the trans pan probably shifted...

Before you tightened it did you make sure it went into every gear properly?

If the plate is a hair off it will cause shifting problems

turyg ls1

iTrader: (2)

Yes everything is tighten up.. I put it in park & then made sure it would clip on to the lever without struggling.. Moved it back & forth & nothing

Burken01

iTrader: (88)

Did you elongate the holes?

It has a sweet spot where everything lines up perfectly..

Tolerances stack up and sometimes it just won't line up, you have to drill more holes into the linkage bracket to adjust it..

turyg ls1

iTrader: (2)

Yes I did elongate the holes.. Are you using the stock shifter as well?

Mystery Bird

iTrader: (7)

Did you adjust the shift cable?

turyg ls1

iTrader: (2)

Yup.. had to adjust it all the way out

turyg ls1

iTrader: (2)

lever suppose to be downwards or upwards? Cause I have it downwards not sure if it matters

Burken01

iTrader: (88)

Put it in park, connect the linkage..

Pull back on the linkage plate till its snug and that's where it needs to be bolted up..

If the holes in the plate don't match the trans pan then make a mark and drill new holes in the bracket..

You'll get it

turyg ls1

iTrader: (2)

Ok.. Ill try that tomorrow cause I've been getting off of work late.. Thanks for the help

Cole Train

iTrader: (30)

Did you end up getting it? i'm gonna be doing this soon and am curious about how this turned out

turyg ls1

iTrader: (2)

No I didn't get it perfect.. but its fine the way it is.