You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join LS1Tech.com today!
I usually torque the bolt's to 110inlbs. Make sure that were the bolts go through the pan that the surface is flat and not dished. Also make sure that the pan rails are flat as well. I have seen some different gaskets for these pans. I have never used a rubber style before. I use either the cork style or the durapreme gaskets with a good straight pan.