1996 blazer 4l60e with a 2003 lm7
#1
Registered User
Thread Starter
1996 blazer 4l60e with a 2003 lm7
I know this has probably been asked before but ive been searching and cant find anything Im building a 96 s10 blazer im trying to keep the original 4l60e transmission the motor thats going into the blazer is out of a 2003 tahoe i have the complete harness with the transmission plug im just trying to figure out what all i need to do to get the transmission to plug into the harness and what else i would need to do the the harness to get the transmission to work any help would be greatly appreciate
#2
TECH Junkie
the electrical side will work the exact same
no changes needed
the tq converter fitment to the 5.3 will be the sticking point
no changes needed
the tq converter fitment to the 5.3 will be the sticking point
The following users liked this post:
s10 blazer swap (02-21-2022)
#3
Registered User
Thread Starter
Ok i have already purchased a flexplate and a torque converter adapter from ict billet im just trying to figure out if the round plug will plug in no issues or if i will have to re pin it to configure to the older transmission and on the harness just up from the round transmission plug is a odd rectangular looking box does it go to the transmission or it it for the gas pedal
#4
TECH Junkie
96 the plug on the trans is the same
post pictures of the box you're referencing
post pictures of the box you're referencing
#7
Registered User
Thread Starter
I have tried uploading a picture of what im referencing but for some reason it wont show the post is there another way i can send you the picture
Last edited by s10 blazer swap; 02-22-2022 at 08:14 AM.
Trending Topics
#8
TECH Junkie
try via PM
#11
TECH Junkie
host the images on imgur and post the link
You must need to wait for the grace period of the forum to post pictures
grace period is so that bots don't just spam accounts and dump a bunch of junk on the forum with their first 10 posts
You must need to wait for the grace period of the forum to post pictures
grace period is so that bots don't just spam accounts and dump a bunch of junk on the forum with their first 10 posts
#12
Registered User
Thread Starter
The picture i was asking you about is the third one but i went ahead and threw them all into a album because those plugs are the ones i dont know what they go to
https://imgur.com/a/TE1Tkz5
https://imgur.com/a/TE1Tkz5
#13
TECH Junkie
the box in question is the neutral safety switch
you've also mislabeled so many plugs in your little post there that I don't even know were to start
I'm not being rude, but you seem to be in a bit deep over your head here. I'd advise checking out the swap section on this forum and maybe lt1swap for some wiring info.
you've also mislabeled so many plugs in your little post there that I don't even know were to start
I'm not being rude, but you seem to be in a bit deep over your head here. I'd advise checking out the swap section on this forum and maybe lt1swap for some wiring info.
#14
Registered User
Thread Starter
No your not being rude I understand completely and ive been using lt1swap.com for everything my next plan to figure out what everything is was to run the wires back to the ecu to see what they go to I appreciate the help