Bowtie Boy

Anyone know about a rough estimate of what it would cost to have a transgo HD2 shift kit installed into a 4l60e or if you payed for an install what was it? I want to get a rough idea before I start calling around.

382ssz28

iTrader: (24)

We charge 2-3 hours plus parts- pan gasket, atf, etc... This includes r&r valvebody, r&r servo, installing the kit, and replacing everything. Hope this helps. Calibration is extra,(computer tuning).

AK's WS6

I think it was around $75 with the trans out of the car. I was done by a friend of a friend, so I wasn't paying a shop rate.

RevGTO

iTrader: (12)

I paid $150 to have a shop do it with the tranny out. This guy does a lot of these and is very familiar with it. It takes time.

StealthFormula

iTrader: (35)

It was around $150ish with 2 hours total of labor.

01ssreda4

iTrader: (96)

was told $225 by one shop.

koolaid_kid

iTrader: (21)

150 sounds about right. The most important part is to find someone who is extremely familiar with the kit. There are some tricks and tips that the experienced installer knows about, including the number of washers to install.
Mine did not need to be tuned to perform great, as far as I can remember (It's been years).

coolformula

iTrader: (21)

GM charges about 400 for the tranny in the car for install.