ITSAV

iTrader: (1)

Well, went to the dyno today, and got everything finished up on my car. I am happy with everything, car ended up putting 380WHP and like 360 ft lbs of torque. For some reason the car didn't like timing at all, it is running stock timing pretty much across the board, tried to increase it but it lost power, so we left it where it was. I have the graph to if I can figure out what program I need to open the files.

But here are the vids

This is an Idle vid
[youtube]TI-_4CPlh0Q[/youtube]

Dyno Vid
[youtube]niHdksf6aKU[/youtube]

JJSimon904

iTrader: (8)

what cam did you go with?

ColeGraham

iTrader: (8)

car sounds sick...good pull bro.

ITSAV

iTrader: (1)

nothing big, just wanted it to be noticeable, but no issues with 100% DDing

226/230 .598”/.600” 113LSA +4 advance (with 1.7 ratio rockers)
Comp EPS/EPS lobes 54-000-11 3 bolt cam core

itsslow98

iTrader: (18)

not a fan of the exhaust setup especially the tips but the car should run good. whats your mod list? What are you revving to? I was still climbing at 6600.

STAGEUP

Judging by your cam specs, its a no brainer why your setup didn't like additional timing.

SOunds good!

ITSAV

iTrader: (1)

no, I am not a fan of the tips either, I just haven't bought replacement ones yet....the ones that are on there, were just made and welded to it.....got to find some tips that I like and get those.....its just hard to find a nice set of tips, as it has a 3 inch inlet