Replace that driveshaft bearing!!!
#647
Sorry it took so long for this post. Haven't put too many miles on the car with the new carrier bushing in, but I'm very pleased with the result. Motor feels smooth again on the highway.
As a bonus, this cleared up some noise I thought was coming from the clutch. There was a "scraping" noise when I pushed the pedal in. I assumed the bearings were shot on the slave but that's gone now.
Thank you voodoo, and everyone else that chimed in with advise.
As a bonus, this cleared up some noise I thought was coming from the clutch. There was a "scraping" noise when I pushed the pedal in. I assumed the bearings were shot on the slave but that's gone now.
Thank you voodoo, and everyone else that chimed in with advise.
#658
TECH Addict
iTrader: (13)
Man, I should have just had voodoo do the shaft for me. Got the kit, the CV joint fell out during the process so I thought, "I'll just service them with this fancy redline grease since I'm here anyway." **** what a pain in the *** to put these together correctly. Gave up and taking the POS to a driveshaft shop, will get it balanced while there. What a fucked up POS this driveshaft is, these CV joints are a BITCH!
#660
TECH Fanatic
iTrader: (5)
Originally Posted by jmilz28
Man, I should have just had voodoo do the shaft for me. Got the kit, the CV joint fell out during the process so I thought, "I'll just service them with this fancy redline grease since I'm here anyway." **** what a pain in the *** to put these together correctly. Gave up and taking the POS to a driveshaft shop, will get it balanced while there. What a fucked up POS this driveshaft is, these CV joints are a BITCH!