Engine mount help!
09-20-2010, 05:04 PM
#1
Teching In
Thread Starter
Join Date: Dec 2009
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Engine mount help! Been working on putting in UUC mounts since this morning. Stock driver's side mount is being stubborn. Engine is fully jacked up, cat removed completely, but I still don't have enough clearance to pull the mount out. Do I have to remove the headers too?
09-20-2010, 11:50 PM
#4
TECH Resident
iTrader: (9)
Join Date: Jun 2008
Location: Mile High
Posts: 869
Likes: 0
Received 0 Likes
on
0 Posts
did you check out the videos on YouTube about replacing CTS-V motor mounts?
Part 1: http://www.youtube.com/watch?v=BAqZ3K3sLQQ
Part 2: http://www.youtube.com/watch?v=aNyz6Dfo9Pw
They helped me a TON as I'm doing mine right now too
Part 1: http://www.youtube.com/watch?v=BAqZ3K3sLQQ
Part 2: http://www.youtube.com/watch?v=aNyz6Dfo9Pw
They helped me a TON as I'm doing mine right now too
09-21-2010, 06:00 PM
#6
TECH Resident
iTrader: (9)
Join Date: Jun 2008
Location: Mile High
Posts: 869
Likes: 0
Received 0 Likes
on
0 Posts
Sure, NP. I did my mounts today too. I pulled off the drivers and got slimed square in the face with the crap oozing out of my drivers motor mount. Both were broken actually. In fact, the drivers was so bad, it was like a pumpkin and the top piece that broke off just moved around like the top to a pumpkin.
