T56 Assembly Question
#1
TECH Enthusiast
Thread Starter
iTrader: (13)
Join Date: Sep 2007
Location: SC
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
T56 Assembly Question
I'm on the last leg of assembling thus T56, and I reached into the bin that I had the cf rings soaking in, and pulled out two very thin spacers/thrust washers. Can anyone tell me where the go? I never noticed them during the tear down
Last edited by GA95DCMSS; 06-01-2014 at 10:38 AM.
#2
Could be shims at the end of the main shaft or counter shaft...hard to tell from a couple words.
Do you have the t56 assembly pdf? It was very helpful when I attempted a rebuild endeavor.
Do you have the t56 assembly pdf? It was very helpful when I attempted a rebuild endeavor.
#3
TECH Enthusiast
Thread Starter
iTrader: (13)
Join Date: Sep 2007
Location: SC
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
Photo added. Couldn't do it from the mobile site. They only fit down to the splined portion of the main shaft, so I'm assuming these would go on the countershaft, I just don't see it in the manual.