Originally Posted by 1994z
not a water or steam fitting. its a vaccumn line. you can cap it or run it to a oil breather tank. you are talking about the valley plate not the heads.
Nevermind I just looked at it and I have no valley port. I was talking about the crossover.
The reason why I asked is because I am blowing oil out of my passenger breather. I am trying to figure out a good pcv setup or breather setup.
Here is a picture of my setup with my old carburetor: http://carphotos.cardomain.com/ride_...4007_large.jpg
The passenger breather is soaked and dripping oil when I rev it hard.