mutang357

I am running a 6.0 swap fox with a AJE K member and trans cross member, I am having issues where it is 6 inches from the Body mount of the trans mount where the collector comes down on the drivers side, has anyone ran into this issue and what have they done to correct? Looks like I would have to run two 45 degree bends to get around the mount, which would kill flow, any suggestions?

ZONES89RS

iTrader: (25)

Man, I simply cut the stock mounts off so it cleared and always made the new trans mount connect to the sub frame connectors. Clears fantastic.

mutang357

thats what i was thinking, plus when i upgrade to a th400, ill get the longer shaft and should work as well

ezstriper

doing one of these now, used 1 7/8 headmans along with their mounts on a QA1 K, only issue was flamming river Ujoint rubbing one tube, other wise great fit