1 gen 350 swap into LT1 car?
#1
Banned
Thread Starter
iTrader: (13)
Join Date: Jan 2008
Location: Alvin,Tx
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
1 gen 350 swap into LT1 car?
I am looking for info on swapping a 1st gen carb'd small block into an LT1 car. I am making this a pure bracket car for my wife and no I dont want to just keep the LT1 stuff. I have a fully forged 355ci setup already completed and doing me no good on an engine stand. I will be going to a TH350 setup as well. Can someone point me in the right direction for all the info I will need?
I read around that the motor mounts and headers should be the same. I also know the Distributor should be a pain in the ***....I am already picking up the new crossmember. Do I need any other suspension parts before I can lay the new set up in?
I read around that the motor mounts and headers should be the same. I also know the Distributor should be a pain in the ***....I am already picking up the new crossmember. Do I need any other suspension parts before I can lay the new set up in?
#6
TECH Fanatic
iTrader: (31)
Join Date: Apr 2007
Location: Dover DE
Posts: 1,207
Likes: 0
Received 0 Likes
on
0 Posts
Problem is the distributor will be a pain in the *** to get to and impossible to remove with the engine in the car. Id just throw the A3 behind the LT1 and put some laughing gas to it. Should make a reliable & fast combo that needs next to no attention.
Re'
Re'