Started the car, ran they wouldnt start again, please Help...
03-04-2009, 03:01 PM
#1
TECH Fanatic
Thread Starter
iTrader: (15)
Join Date: Jan 2005
Location: Long Island, NY
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
Started the car, ran they wouldnt start again, please Help... Got the Ls1 started today. started and all was well. turned it off, started again and it ran fine. Went to start it later on and it would just crank. I can smell the fuel, i checked all fuses they seem fine. It just cranks. I can assume no spark but i can not be positive. Any input ? Also i am not sure the serial port is working. would that have anything to do with it ?
Tom
Tom
03-04-2009, 05:52 PM
#5
TECH Fanatic
Thread Starter
iTrader: (15)
Join Date: Jan 2005
Location: Long Island, NY
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
pcm has not had power in a month. i was doing the swap. plugs were used but appeared to be recently replaced when i looked at them last week
Trending Topics
03-05-2009, 11:01 AM
#9
TECH Fanatic
Thread Starter
iTrader: (15)
Join Date: Jan 2005
Location: Long Island, NY
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
yea i know, i am thinking i mixed up the engine sensor wire with something. Pin g on blue 230 doesnt have power when i turn the key to run.
03-06-2009, 12:24 PM
#12
Launching!
iTrader: (22)
Join Date: Nov 2005
Location: TX 76511
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
I would not think that the ECT sensor would cause it not to run.. did you get your MAF fixed? when you say "floor it" do you mean just press on the pedal or do you mean to the floor? how does the motor run? If you are having to press on the pedal that sounds normal for a PCM that has been setting and running in SD mode.. has you modded the motor? Cam and such
03-06-2009, 12:34 PM
#13
TECH Fanatic
Thread Starter
iTrader: (15)
Join Date: Jan 2005
Location: Long Island, NY
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
motor is stock. got the maf hooked and power to it. Still saw the maf code today though. Pedal had to be touching the floor before for it to start. Now it seems fine. Still have that ect code, and the fans are always on.
03-06-2009, 03:19 PM
#15
TECH Fanatic
Thread Starter
iTrader: (15)
Join Date: Jan 2005
Location: Long Island, NY
Posts: 1,474
Likes: 0
Received 0 Likes
on
0 Posts
I will have to try that. And yes i cleared the maf code. The coolant temp gauge on my dash reads fine but my aeroforce is not reading it.
