LS1 swap wiring question
#1
On The Tree
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
LS1 swap wiring question
I have a ls1 in a old chevy .I just installed a moroso batt dis connect switch and have a question.Should I always keep a 12 volt source for the computer?I have a wire on the John Speartech modded harness and see a wire marked always hot,will the computer have to go through a learning curve every time I use the disconnect switch?Thanks Dan
computer and harness out of a 2004 gto if it matters!
computer and harness out of a 2004 gto if it matters!
#4
TECH Fanatic
iTrader: (13)
I also have a cutoff switch. Initially I did not have it wired always hot and never had much of a problem if I shut the power off for a day or two. Since then I have taken the orange wire from my Speartech harness and connected it to the input side of the switch so it always has 12v as long as the battery is installed. That was guidance I got from John.
Pat
Pat