o2 sensor pic request
10-14-2009, 01:01 AM
#1
TECH Resident
Thread Starter
iTrader: (30)
Join Date: Nov 2007
Location: Van Nuys
Posts: 823
Likes: 0
Received 0 Likes
on
0 Posts
o2 sensor pic request tryin to piece together some parts and havin some issues. i bought a set of o2 sensors for my swap but i think cause my harness they wont work.my motor is a 5.3l but i think my harness is from a 6.0l
is there a difference in o2 sensor plugs from a ls1,lm7 and lq4 harness? any pics of the plugs? oh its for the front set, the rears got deleted out.
is there a difference in o2 sensor plugs from a ls1,lm7 and lq4 harness? any pics of the plugs? oh its for the front set, the rears got deleted out.
10-14-2009, 02:32 PM
#3
TECH Resident
Thread Starter
iTrader: (30)
Join Date: Nov 2007
Location: Van Nuys
Posts: 823
Likes: 0
Received 0 Likes
on
0 Posts
i think i might have the same as you.
the ones i have look like this. (i did notice that the harness that goes to the rear has this style)
i think i might need this style
the ones i have look like this. (i did notice that the harness that goes to the rear has this style)
i think i might need this style
11-09-2009, 06:48 PM
#6
Staging Lane
Join Date: Apr 2009
Location: Long Beach Ca
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
I would need to check my wireing harness but, i know i have different plugs for the front and rear o2's.
I have 4 o2's thatg look like "D" in the above picture (the end looks like the opposite ,mail version of what you have RPD_Vette84). I also have 2 o2's that look like the second ones you posted. I think I need eather the ones you say you have "E" in my picture or i think "C" in my picture depending on which ones are the front two on my harness. I would be up for a trade or sale
I have 4 o2's thatg look like "D" in the above picture (the end looks like the opposite ,mail version of what you have RPD_Vette84). I also have 2 o2's that look like the second ones you posted. I think I need eather the ones you say you have "E" in my picture or i think "C" in my picture depending on which ones are the front two on my harness. I would be up for a trade or sale
Trending Topics
11-09-2009, 09:29 PM
#9
Be careful, the black square and black flat O2s will interchange, however, the gray/white squares will NOT. Gray/white squares were used on the green/blue pcms and are grounded through the PCM. The black square and black flats (just like those used on the LT1s) are grounded through the case of the O2 sensor and are used on the 411 and other red/blue PCMs.
__________________
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
