Looking to convert a 98 Jeep Grand Cherokee Laredo 4x2
#1
Looking to convert a 98 Jeep Grand Cherokee Laredo 4x2
Does any body here know where I can buy a conversion kit for this year model of Jeep or if they even offer one? All I need are the engine and tranny mounts. Here's what I have right now.
-03 5.3 complete engine with wiring and computer
- 4L60E for a two wheel drive.
-03 5.3 complete engine with wiring and computer
- 4L60E for a two wheel drive.
#3
On The Tree
iTrader: (14)
Join Date: Jan 2008
Location: Baltimore, MD
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
I'd check out Novak. I haven't done a Jeep conversion but was looking for a while.
http://www.novak-adapt.com/index.htm
Frank
http://www.novak-adapt.com/index.htm
Frank
#6
You can also try these guy's http://www.advanceadapters.com/
I have had good luck with them in the past.
GL !
I have had good luck with them in the past.
GL !
Trending Topics
#8
No one makes a kit to swap an LSX into a Grand Cherokee. I'm swapping one into mine at the moment, the build thread is here:
Starts about a quarter of the way down the page.
http://www.mallcrawlin.com/forum//sh...t=16671&page=2
Starts about a quarter of the way down the page.
http://www.mallcrawlin.com/forum//sh...t=16671&page=2
#9
I always wanted to swap a LSx into a 98+Grand Che*****
That guy has skills.
That guy has skills.
#10
Yeah I have a 94 limited that I would love to drop a 5.3 in but no one makes the mounts
yet that I know of... Keep us updated! Lots of fellas doin XJ's now but we need mall
crawlers!
subscribed
yet that I know of... Keep us updated! Lots of fellas doin XJ's now but we need mall
crawlers!
subscribed
#11
For motor mounts I'm using half of Advance Adapter's TJ swap kit. I'm using their engine side mounts and for the frame side I welded my own up to bolt to the factory locations.
Passenger side:
Driver side installed:
Passenger side:
Driver side installed:
#12
tig welder
thanks,
Jim
#13
Actually that is a 200A MIG in the background, but I own a Lincoln Invertec TIG that is amazing. It does DC & AC and will do about 1/4" aluminum if I preheat it, a little thicker on the steel side.