Calling all 67 chevelle Guru
01-01-2010, 09:43 PM
#1
Launching!
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: Monsey NY
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
Calling all 67 chevelle Guru Am having trouble looking for a company that make crossmember for the 4L60E tranny crossmember. Can someone chime in with this ?
01-02-2010, 05:56 PM
#2
TECH Resident
iTrader: (10)
Join Date: Oct 2005
Location: Cincinnati, Ohio
Posts: 948
Likes: 0
Received 0 Likes
on
0 Posts
You can use the stock crossmember. You don't want the rear of the trans any lower than it sits on the stock crossmember or you might have pinion angle (vibration) problems.
01-04-2010, 10:08 AM
#4
Launching!
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: Monsey NY
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
My stock crossmember is too short. Do I have to cut the tab off and mod up a new tab to make it fit ? Kevin do you have any pics on your crossmember ?
Trending Topics
01-05-2010, 06:51 PM
#8
TECH Resident
iTrader: (10)
Join Date: Oct 2005
Location: Cincinnati, Ohio
Posts: 948
Likes: 0
Received 0 Likes
on
0 Posts
Oh sounds like you need to find a good used crossmember. Are you a member of Team Chevelle? www.chevelles.com
01-06-2010, 05:15 PM
#9
Launching!
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: Monsey NY
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
I still have mine crossmember . Just the tab that connect to the tranny mount that I cut off and sant seem to find it anywhere. Yes am an chevelle member
01-07-2010, 01:30 PM
#13
Staging Lane
Join Date: Apr 2009
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
in terms of tunnel it depends how far back into the firewall you set the engine. you're bringing up fun memories of when i was trying to balance the tolerances between the firewall, steering box, crossmember, pinion angle, and trans tunnel.
fun times... NOT!
fun times... NOT!
