Paul57

I would like to run the water temp (gauge) sensor and fan temp (on/off) sensor from the same point in the passenger side head. Is this possible or do I need to run one of them to the drivers side head??

I asked this question in another area but I thought you guys may have a little more experience with non-factory items.

Pocket

iTrader: (22)

Using a 98 3 wire sensor, you combine PCM CTS and gauge sender into one point. Generally, fan control is done by the LSx PCM rather than the older thermo switch

Paul57

I should have mentioned...I am not running EFI (PCM).

Pocket

iTrader: (22)

Why not?

To answer your question, no Ive never seen a dual output switch. The gauge sender varies resistance in relation to temperature. The switch is either fully open or fully closed depending on temperature