Harness questions
#1
Staging Lane
Thread Starter
iTrader: (4)
Join Date: Jan 2007
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Harness questions
Hey everyone. I have a 6.0 lq9 and i also have the harness that came with the motor. Its for the motor and 4l80e. Problem is the motor is going in a toyota 4x4 and I need it to be repined so that is will work with the motor and a turbo tranny. Basically a 6 spd harness out of this harness. I also need the obd port to work for tuning the vehicle. WHats the best way to do this. I didnt get the whole complete obd harness i just undid the port and cut the I think 4 wires back about 6 inches. THanks so much for the info
#2
TECH Regular
iTrader: (5)
Join Date: Aug 2009
Location: Swedesboro, NJ
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
Call speartech, current performance and wait4me performance and see who can do it for you for the cheapest. There are other companies that do custom harness mods but those 3 are all I can think of.
#4
Staging Lane
Thread Starter
iTrader: (4)
Join Date: Jan 2007
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
well any other suggestion? I cant see paying someone the price they want to redue a harness. Can buy a 6 speed harness cheaper. Any suggestion that I should do. OR a diagram to go by... I see the harnesses on ebay for 349 brand new THanks again
#5
sawzall wielding director
iTrader: (4)
did you check out the FAQ sticky wiring info? There isn`t really anything special that needs to be done to that harness to make it work. You could strip the extra wires out or just leave them hanging. Your motor will have better driveability if you figure out some way to put in a park/neutral switch and VSS, but you can get away without them.