Newbie O2's wont read
10-10-2010, 06:06 PM
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Jan 2010
Location: SW Florida
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
Newbie O2's wont read I have the Bosch Generic O2 sensor in the driver side of an L92 and LC-1 Wide band in the other.
Both give an "Mv" read on EFI live but cannot get Lambda or any O2 readings. I just replaced one Bosch so its brand new, thought maybe I wired it wrong or cooked it. Still no go.
Two wires are heater and the other two are sensor high and sensor low so pretty sure its wired correct.
Any ideas?
Note: Sensors are located in band clamps just after my hooker long tube headers.
Both give an "Mv" read on EFI live but cannot get Lambda or any O2 readings. I just replaced one Bosch so its brand new, thought maybe I wired it wrong or cooked it. Still no go.
Two wires are heater and the other two are sensor high and sensor low so pretty sure its wired correct.
Any ideas?
Note: Sensors are located in band clamps just after my hooker long tube headers.
Last edited by 68Problemchild; 10-10-2010 at 09:03 PM.
