figured that since this was the hybrid section
#1
Staging Lane
Thread Starter
Join Date: Jun 2006
Location: OKC, OK
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
figured that since this was the hybrid section
i'm going to put a SBC in my 89 mustang... i'm sure people on here have done this but havnt found any threads with a parts list?????
thanks
thanks
#2
TECH Fanatic
iTrader: (23)
Do you mean old-school SBC? Probably have more luck on a mustang forum I would think, I know I've read about people doing this. People use ford rear ends with sbcs all the time, so I bet you could just mimic those setups, make some motor mounts, get a driveshaft cut and throw it in there. Complete speculation on my part though. No idea how you'd wire it up.
#3
TECH Enthusiast
iTrader: (10)
Join Date: Jun 2010
Location: Boston
Posts: 728
Likes: 0
Received 0 Likes
on
0 Posts
Parts list will include all the acc, motor/trans, motor mounts, tranny mounts, custom cut drive shaft, and maybe a conversion u joint to mate up mix matched parts.
Just swap iin an lm7, i've seen full pullouts for around 1k All you need to do is install it, remove vats and turn the key.
Just swap iin an lm7, i've seen full pullouts for around 1k All you need to do is install it, remove vats and turn the key.