leon phelps

Would anyone have a photo of how they got the wire from the harness down the engine to the sensor?

I am not thrilled with the way mine is routed. I have it next to the plug wire.

thanks in advance.

BelAir1000

iTrader: (1)

I plan to route mine down the right side bell housing with the starter solenoid and r/s knock sensor wiring. I am referring to a 07 L92. Not sure if they're all the same. I plan to wrap the wires with the metallic heat tape.

leon phelps

that may be a plan, heat tape.

thanks.

Pocket

iTrader: (22)

Like this, no heat tape

leon phelps

you mean try not to use the heat tape or you are not using it Pocket?

Old Geezer

iTrader: (3)

how I did mine. I ty wrapped the entire wire bundle to the starter. keeps it away from the exh.

scatillac

iTrader: (12)

Heat tape is like beer: You can never have too much , but you can have not enough.........

Pocket

iTrader: (22)

No heat tape. At its closest, the bundle is still over an inch away from the exhaust. Even if it was laying on a primary tube, it still shouldnt ever get above the heat rating of the split loom unless the engine was running lean causing the headers to glow

gMAG

iTrader: (1)

Me, too.