How do i convert my ls2 gto to speed density instead of MAF
03-19-2011, 01:05 PM
#4
TECH Fanatic
iTrader: (14)
Join Date: Mar 2007
Location: Phoenix/Tempe, AZ
Posts: 1,969
Likes: 0
Received 0 Likes
on
0 Posts
hire a tuner
for the IATS you can install one inside your intakes bellows (however you may have it setup)
usually an initial tune is a few hundred bucks for a dyno tune.
for the IATS you can install one inside your intakes bellows (however you may have it setup)
usually an initial tune is a few hundred bucks for a dyno tune.
03-19-2011, 07:54 PM
#5
TECH Apprentice
iTrader: (10)
Join Date: Aug 2008
Location: Winnipeg, Manitoba
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
Go to DIY autotune and pick up a IATS and pigtail. $30
Find a good spot to drill/tap/install it.
2 Wires out of the maf harness (5 total) are the IATS wires. Determine these by the specific pin-out diag for your harness.
Swap out your current MAP sensor with a cobalt 2 bar map sensor from "frost" or the generic 3bar sensor (will need to de-pin and rewire). ~$80
Get a tuner or tuning program (tuner recommended if you don't know about tuning in general) and get the proprietary software installed. $400+ for the tuner or ??? for a dyno tune.
Find a good spot to drill/tap/install it.
2 Wires out of the maf harness (5 total) are the IATS wires. Determine these by the specific pin-out diag for your harness.
Swap out your current MAP sensor with a cobalt 2 bar map sensor from "frost" or the generic 3bar sensor (will need to de-pin and rewire). ~$80
Get a tuner or tuning program (tuner recommended if you don't know about tuning in general) and get the proprietary software installed. $400+ for the tuner or ??? for a dyno tune.
03-19-2011, 09:57 PM
#6
Go to DIY autotune and pick up a IATS and pigtail. $30
Find a good spot to drill/tap/install it.
2 Wires out of the maf harness (5 total) are the IATS wires. Determine these by the specific pin-out diag for your harness.
Swap out your current MAP sensor with a cobalt 2 bar map sensor from "frost" or the generic 3bar sensor (will need to de-pin and rewire). ~$80
Get a tuner or tuning program (tuner recommended if you don't know about tuning in general) and get the proprietary software installed. $400+ for the tuner or ??? for a dyno tune.
Find a good spot to drill/tap/install it.
2 Wires out of the maf harness (5 total) are the IATS wires. Determine these by the specific pin-out diag for your harness.
Swap out your current MAP sensor with a cobalt 2 bar map sensor from "frost" or the generic 3bar sensor (will need to de-pin and rewire). ~$80
Get a tuner or tuning program (tuner recommended if you don't know about tuning in general) and get the proprietary software installed. $400+ for the tuner or ??? for a dyno tune.
Sorry, why would you change the MAP to a 2 or 3 BAR? OP never said anything about a blower. All your doing is losing resolution by (needlessly) increasing the range...
