LS T56 Bracket
10-04-2011, 07:35 PM
#1
On The Tree
Thread Starter
iTrader: (3)
Join Date: Aug 2010
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
LS T56 Bracket I need the hydraulic clutch bracket that bolts behind the brake booster. My car has power front discs. Do i need to go manual to make this work? I don't see how the clutch master would fit behind the power brake booster? Anyone with a 70-72 chevelle w power brakes done this? Any help would be much appreciated.
10-05-2011, 12:31 AM
#2
Yes. you can find the template in the FAQ.. it does work well.. S&P markets one.. you might find other on the internet. it is not hard to make from 1/8" or 3/16" metal.
I bolts behind the booster and against the firewall. the Master will then be below the booster and angling away from it. If you look at a 4th gen master. the firewall mounting surface is at a angle. Which is why you need the bracket.
1st page of this thread show the template.
https://ls1tech.com/forums/conversio...ro-basics.html
Also if you research on some of the there swap threads you will find info..
You can see what I did on my swap by using the link in my sig..
I bolts behind the booster and against the firewall. the Master will then be below the booster and angling away from it. If you look at a 4th gen master. the firewall mounting surface is at a angle. Which is why you need the bracket.
1st page of this thread show the template.
https://ls1tech.com/forums/conversio...ro-basics.html
Also if you research on some of the there swap threads you will find info..
You can see what I did on my swap by using the link in my sig..
10-05-2011, 08:42 AM
#4
I bought (but have not used) this - http://www.ebay.com/itm/ws/eBayISAPI...X%3AIT&vxp=mtr
Can't speak for the fit but the quality of the piece and it's finish is very high. Of course we are talking about $30 for a bent piece of metal, but nevertheless it is higher quality than I expected. I think 71fakes bought one as well.
Can't speak for the fit but the quality of the piece and it's finish is very high. Of course we are talking about $30 for a bent piece of metal, but nevertheless it is higher quality than I expected. I think 71fakes bought one as well.
10-05-2011, 01:09 PM
#6
On The Tree
Thread Starter
iTrader: (3)
Join Date: Aug 2010
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
Ok Thanks guys. So the 4th Gen master cylinder is What everyone uses? I've bought the original GM 4 speed pedal kit so There's not much more I need to get the trans into My chevelle.
