4l60E & Dakota Digital gauges
#1
On The Tree
Thread Starter
4l60E & Dakota Digital gauges
I have been searching the internet & I cant find nothing on how to make my DD gauges work with a 4L60E trans. Im sure its a way to get gauges to pick up the speed signal from the computer. Has anyone done this before?
#3
On The Tree
Thread Starter
#4
TECH Apprentice
iTrader: (2)
I put DD in my 71 velle, w/4l80e. I told them what I was doing and everything came with it.... I didn't have any trouble setting it up. I did get the gear indicator accessory. It was all strait forward, just followed the instructions... Ialso got their cruise control,and rear view mirror..Cool stuff...
Rick
Rick
#5
On The Tree
Thread Starter
I put DD in my 71 velle, w/4l80e. I told them what I was doing and everything came with it.... I didn't have any trouble setting it up. I did get the gear indicator accessory. It was all strait forward, just followed the instructions... Ialso got their cruise control,and rear view mirror..Cool stuff...
Rick
Rick
#6
The Dakota VHX gauges count the vss pulses for one mile to calibrate the gauge. Or they have the mechanical screw in speedo that converts to a pulse signal. Not sure how the older ones work, but their tech support is pretty good.
Trending Topics
#8
On The Tree
Thread Starter
#10
TECH Enthusiast
iTrader: (2)
Join Date: Aug 2008
Location: Alberta, Canada
Posts: 617
Likes: 0
Received 0 Likes
on
0 Posts
My DD gauges installed easy. I used the VSS output wire, just tapped into that and programmed the DD computer with the up and down buttons. I just followed the instructions that came with the gauges.
#11
11 Second Club
iTrader: (18)
Just installed these and tapped the vss purple wire at the trans.
Now the PCM is throwing a low signal code from the vss.
Do I have to use the vss out pin in the PCM or is something else wrong.
EDIT: went back and followed directions above to tap the pin 55 green/white wire instead and now everything works perfectly
Now the PCM is throwing a low signal code from the vss.
Do I have to use the vss out pin in the PCM or is something else wrong.
EDIT: went back and followed directions above to tap the pin 55 green/white wire instead and now everything works perfectly
Last edited by thunderstruck507; 03-19-2013 at 04:34 PM.