red347lx

Looking at buying a K member for my notch and have seen everyone uses AJE. Has anyone used Team Z's K member, and if so what are your thoughts on fitment and routing of headers? I would like to use Team Z since they are made here in Michigan, but I would like some feedback from those who have and those who like their AJE.

boostnut

iTrader: (7)

I work in a tube fabrication shop & bought an AJE for my 95. Not a bad piece but not the quality I'm used to. If I had it to do again I'd buy a Team Z BUT I have the ability to fab my own headers, not something just everyone can do or wants to do.

Has anyone confirmed Dynatech or Kooks header fitment with Team Z's k-member?

red347lx

Dave had his K member jigged around Dynatech headers so I am sure the fitment is good.

dville_gt

iTrader: (5)

I have the AJE in my coupe w/a turbo 6.0 and solid mounts, has held up fine.

86lxnotch

iTrader: (3)

i dont have the swap k member but a normal 5.0 one from dave and its high quality imo. ive use a few aje's on other cars and never like the wuality very much. dave's stuff has time into it rather than slapped together like aje's stuff

suicidal racing

iTrader: (14)

not sure where your located but i have a aje k mem for sale..i got it for sale as a whole front take out right now..you get the whole front suspension for 1k and new aero space manual brake kit..this is new k mem with chevy mounts,new adj strange struts and coil over kit,upr tube a arms,qa1 coil over springs,new upr c/c plates,v8 spindles and new lincoln 5 lug rotors..i just put it all on my race car i was doing and have decided to part it out and build a street car now instead..

snipes

iTrader: (14)

I just picked up the AJE piece for my 79 Notch build, looks to be a pretty stout piece. S-K Speed (vendor here) has some killer deals on them.

red347lx

PM sent to suicidal racing.