jlay

iTrader: (2)

Guys, I ordered some stainless works headers for my 67 camaro ls2 and I am told they have been waiting on a new design for better clearance by the steering box. This has been since October, has anyone heard the same story? Thanks in advance!

Rocketrod

iTrader: (2)

I haven't heard that, but I am going to call them. I have a set and I am not impressed with the fit.

jlay

iTrader: (2)

I did not order mine directly from SW, I ordered them from a vendor. That is why I am trying to see if I am the only one getting this story.

bmf5150

Yeah mine are tight on my steering box to

Rocketrod

iTrader: (2)

I called Stainless Works and left a message asking about this. Hopefully I will here back from them tomorrow.

Rocketrod

iTrader: (2)

I talked to Paul at Stainless Works today and he confirmed they are working on a new design for added clearance. He didn't get a completion date, but he said one of their distributors is test fitting the new design. As we talked it just so happened this distributor is the vendor I bought my headers from...

jlay

iTrader: (2)

OK, So is mine, must of bought them from the same guy.

StainlessWorks

Ok, time to shed some light on this one.......

We are making a very slight change to the L2 primary (cylinder 3) on our CALS1SB header. The slight change will give some extra clearance (3/16" of an inch) to allow for improved fitment. This should allow the use of some aftermarket steering boxes, which are typically a bit larger than the stock steering box these headers are intended to fit. Keep in mind every steering box is different in dimension, so we cannot guarantee fitment to everything, as I'm sure you can understand why. We are in the process of making this slight change and verifying fitment to improve our application coverage.

Paul