Need4Camaro

iTrader: (1)

Are there any differences besides the bellhousings?

Rick Speed

iTrader: (55)

You don't need to swap belhousing to make them fit. They both bolt right up the problem is the torque convertor.

socal

iTrader: (1)

yes, it's not the bell houseing it's the convertor spacer thats needed if your reusing your LT 4L60e this is what youll need or something like it

http://www.jegs.com/i/JEGS+Performan...01010/10002/-1

http://www.jegs.com/i/JEGS+Performan...01011/10002/-1

Need4Camaro

iTrader: (1)

Im doing an LS1 swap and I believe I was delivered an LT1 transmission by mistake. Im most likely going to have to return it though. The Torque converter hits flexplate before bellhousing hits block and that spacer will make it worse. Any other ideas?

Rick Speed

iTrader: (55)

Maybe it popped out and is just not fully seated. You'll need to spin it and push in at the same time and it'll pop in another inch.

bad67ls

iTrader: (2)

converter isnt all the way in.

Need4Camaro

iTrader: (1)

The converter or flexplate?