Glide with LS - Use Manual Wiring and PCM?
#1
TECH Resident
Thread Starter
iTrader: (11)
Join Date: Jun 2008
Posts: 825
Likes: 0
Received 0 Likes
on
0 Posts
Glide with LS - Use Manual Wiring and PCM?
Hey guys,
I have an embarrassingly stupid question. I beleive I am right but wanted to confirm. When using an LS engine with a non electronic trans (glide in this case) I assume I use a manual wiring harness to complete the swap. Where I get a little fuzzy is what else needs to be done with regards to VSS and any PCM mods.
Any help is appreciated and if there are some threads I could be direct to to read about it that would be appreciated as well. I seem to be coming up empty when searching and since I have a little one on the way my time is limited with doctors appointments and working and taking care of my wife.
Thanks in advance to anyone who could help.
Dave
I have an embarrassingly stupid question. I beleive I am right but wanted to confirm. When using an LS engine with a non electronic trans (glide in this case) I assume I use a manual wiring harness to complete the swap. Where I get a little fuzzy is what else needs to be done with regards to VSS and any PCM mods.
Any help is appreciated and if there are some threads I could be direct to to read about it that would be appreciated as well. I seem to be coming up empty when searching and since I have a little one on the way my time is limited with doctors appointments and working and taking care of my wife.
Thanks in advance to anyone who could help.
Dave