7.5 carrier please help
#1
Staging Lane
Thread Starter
Join Date: Jun 2011
Location: chicago
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
7.5 carrier please help
Can i put a posi carrier out of a up to a 92 s10 into my 79 monte carlo 7.5 rearend. If not which one can i use or what should i use. I know that there is something i can use without dumping alot of money in something ive never done.
#6
Staging Lane
Thread Starter
Join Date: Jun 2011
Location: chicago
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
#7
TECH Resident
iTrader: (2)
Just weld it up then,you will just break whatever Vega 7.5" stuff you will scrounge up.
There are a lot of variations in axle splines,pinion bearings,posi units,2,3,4 series carriers.Its just too much of a crap shoot to pin point exactly where to look,you will just have to pull some units and see what matches up with your housing.
There are a lot of variations in axle splines,pinion bearings,posi units,2,3,4 series carriers.Its just too much of a crap shoot to pin point exactly where to look,you will just have to pull some units and see what matches up with your housing.
Trending Topics
#9
TECH Addict
iTrader: (4)
26 to 28 spline axle changeover wasn't a definite year; S10s got 26 into the early 90s. Some V6 f-bodies got them later than 88 too.
An Eaton is a quality "posi" available in 26 spline.
The stock Auburns with cone frictions are usually unrebuildable when worn out.
If you don't know what you're talking about, don't bother providing misinformation. And take racing out of your username while you're at it.
An Eaton is a quality "posi" available in 26 spline.
The stock Auburns with cone frictions are usually unrebuildable when worn out.
Just weld it up then,you will just break whatever Vega 7.5" stuff you will scrounge up.
There are a lot of variations in axle splines,pinion bearings,posi units,2,3,4 series carriers.Its just too much of a crap shoot to pin point exactly where to look,you will just have to pull some units and see what matches up with your housing.
There are a lot of variations in axle splines,pinion bearings,posi units,2,3,4 series carriers.Its just too much of a crap shoot to pin point exactly where to look,you will just have to pull some units and see what matches up with your housing.