Heater hoses
#1
TECH Senior Member
Thread Starter
iTrader: (7)
Heater hoses
I am trying to get some heat in my RX7. There are 2 fitting on the side of the water pump for the heater hoses. One is large the other is smaller.
Which one goes TO the heater core and which is the return?
Thanks!
Andrew
Which one goes TO the heater core and which is the return?
Thanks!
Andrew
#6
9 Second Club/LS1TECH Sponsor
iTrader: (14)
Yes, the front (larger fitting) is the return. In fact, on my 5.3 Envoy they take the cylinder head purge line directly into the larger heater hose. That might be a handy tip for those trying to figure out what to do with the purge line when you don't have the extra nipple on your radiator.
The black hose you see here is the cylinder head purge line teeing into the heater hose.
The black hose you see here is the cylinder head purge line teeing into the heater hose.
__________________
91 Z28 LS2 408CI, LS9 Supercharger, LPE GT7 cam, Yank3000, 3450 raceweight.
Latest numbers: 9.71 ET, 141.42 MPH, 1.40 60' , 610 RWHP Mustang Dyno
www.speartech.com
91 Z28 LS2 408CI, LS9 Supercharger, LPE GT7 cam, Yank3000, 3450 raceweight.
Latest numbers: 9.71 ET, 141.42 MPH, 1.40 60' , 610 RWHP Mustang Dyno
www.speartech.com
#7
TECH Senior Member
Thread Starter
iTrader: (7)
John,
Thank you SO much. That is exactly the information I was looking for. I am installing a remote radiator filler in my RX7 and I needed to run a hose from the filler to the sucksion side of the water pump. Now I have my spot!
Thanks again!
Andrew
Thank you SO much. That is exactly the information I was looking for. I am installing a remote radiator filler in my RX7 and I needed to run a hose from the filler to the sucksion side of the water pump. Now I have my spot!
Thanks again!
Andrew