my ls1 engine progress
#1
my ls1 engine progress
finally got my long block finished. Im waiting on my Victor Jr. and MSD ignition. Im most likely going to send the manifold out for porting.
LS7 lifters
Melling high volume oil pump
Wegner Motorsports valley tray
TSP pushrods
MS3
PRC stage 1 LS6 heads
Roll Master double timing chain
APS pulley
ARP head bolts
ARP rod bolts
ARP balancer bolt
ARP rear cover bolts
Auto Craft pan and pickup
all new gaskets
truck oil filter
as delivered
tear down and paint
clean and fresh!
LS7 lifters
Melling high volume oil pump
Wegner Motorsports valley tray
TSP pushrods
MS3
PRC stage 1 LS6 heads
Roll Master double timing chain
APS pulley
ARP head bolts
ARP rod bolts
ARP balancer bolt
ARP rear cover bolts
Auto Craft pan and pickup
all new gaskets
truck oil filter
as delivered
tear down and paint
clean and fresh!
#5
its going in my 69 camaro. Its going to be carbed. I picked up the valley tray from wegner motorsports. they are the company that developed the distributor drive for the front of the engine. I got the coils mounted up on it today and also got a few parts in the mail. im waiting for my victor jr intake to arrive as soon as that happens im going to take it to westech for a dyno session. i hope i can crank out close to 520 at the crank, or roughly 430-440 at the wheels.
this will be its new home
this will be its new home
Trending Topics
#8
thank you for the comments. ill let everyone know how things turn out. i wish i had the money to buy everything for my swap at once, but i dont. i need to sell my current SBC and M22 4 speed to finance the fuel system and ATS T56 kit.
my goal for the swap was to show everyone that a carb setup can be worth it.
my goal for the swap was to show everyone that a carb setup can be worth it.
#12
thank you. i also fashioned some mounts for a 2001 F body radiator to fit on a repo 69 camaro radiator. my dad is taking it to a shop today to have the inlet and outlet sizes changed. also ordered a sumpped gas tank. soon as all that arrives i can start to wire it up.
Last edited by DCx; 01-16-2008 at 03:45 AM.