Where did you get your LS1 pullout? (again)
#1
On The Tree
Thread Starter
Join Date: Jul 2006
Location: Weld, ME
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
Where did you get your LS1 pullout? (again)
There was a thread titled something like this but I can't find it now. I reformatted my harddrive a week ago and forgot to write down my bookmarks, so I lost them. Now I can't seem to remember the few sites I had that sold pullouts. One was cleveland pick-a-part, another was tacreationsusa.com. I can't think of any of the others. I'm going to be ordering my ls1/t56 pullout tomorrow so any more sites/phone numbers would be great.
#2
Teching In
Join Date: Dec 2005
Location: Southeast Michigan (Detroit area)
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
I used cleveland pick a part and was real happy with them. There is a place called Schram Auto Parts in Michigan and a place called F-Parts that I believe is in Western Pennsylvania. The best bet to search on LS1 on Ebay.
#5
TECH Senior Member
iTrader: (127)
y not look into a 6.0 based engine?
they weigh like 70 lbs more than the alloy block, but they have a larger bore
and can be over bored to .030=370ci
someone will always need the 317 heads for fi, so u can sell those and get some cash back if not used,
i would recommend u rebuild the 6.0 and t56 so u can start out with a frsh start as opposed to using stuff u prolly got from enthusiasts that has been
banged on and raced
.02$
they weigh like 70 lbs more than the alloy block, but they have a larger bore
and can be over bored to .030=370ci
someone will always need the 317 heads for fi, so u can sell those and get some cash back if not used,
i would recommend u rebuild the 6.0 and t56 so u can start out with a frsh start as opposed to using stuff u prolly got from enthusiasts that has been
banged on and raced
.02$